Sony SRW-5000 Installation Manual page 12

. Attaching the rack angles (handles)
8. Remove the four screws from both sides (left and
right) of the unit.
B4 x 6
n
Keep these screws (B4 x 6).
Be sure to use these screws when directly fixing the
side panels without the rack angles.
The use of longer screws such as the screws (PSW 4 x
16) for fixing the rack angles will cause a malfunction
of the unit.
9. Attach the two rack angles to both sides (left and right)
of the unit with the four screws (PSW4 x 16) supplied
with the rack mount kit.
Tightening torque: 120 x 10
PSW4 x 16
Rack angle
PSW4 x 16
1-6
B4 x 6
_2
N.m {12.2 kgf.cm}
Rack angle
PSW4 x 16
. Loosely attaching the rail brackets
10. Slide the intermediate rail as shown in the figure, and
then loosely attach the rail bracket to the outer rail
with a plate nut (large) and the two screws.
Plate nut (large)
Rail bracket
Outer rail
Intermediate rail
11. Slide the ball retainer in the direction of the arrow, and
then loosely attach the rail bracket to the outer rail
with a plate nut (large) and the two screws.
Plate nut (large) Rail bracket
Slide
B4 x 8
Outer rail
Slide
Intermediate
rail
Ball retainer
B4 x 8
SRW-5000