Attaching The Slide Rails To The Rack - HP 5920 Switch Series Installation Manual

1. Choose a grounding point.
2. Unpack the grounding cable and grounding screws.
You can use the cable and screws shipped with the switch only for connecting to the primary
grounding point or auxiliary grounding point 1.
3. Align the two-hole grounding lug at one end of the cable with the grounding holes of the
grounding point, insert the grounding screws into the holes, and tighten the screws with a
screwdriver to attach the grounding lug to the chassis, as shown in
Figure 8 Attaching the rear mounting brackets/chassis rails/grounding cable to the chassis
Figure 9 Attaching the front mounting brackets/chassis rails to the chassis

Attaching the slide rails to the rack

10
Figure 8.