Door Reversal - Russell Hobbs RHUCLF1 Instruction Manual

You will need to tilt the fridge backward to access the lower hinge which holds
screws. Do not tilt more than 45 degrees and do not lay the fridge flat on its side.
For your own safety, a minimum of 2 people should lift or tilt this product.
Before reversing your door, remove the top cover of your unit by removing the
Reversing the door:
1. Remove the upper hinge cover.
2. Remove the two screws that hold the upper hinge (right side) to the fridge body.
Remove the upper hinge.
3. Lift the door and place it on a padded surface to prevent scratching.
4. Reverse the whole cover plate from the left side to the right of the door.
5. Remove the two screws that hold the lower hinge and remove the lower hinge.
6. Remove the left front foot and transfer it to the right side.
7. Before fitting the lower hinge, swap over the hinge pin from left to right and the
foot to the other side of the lower hinge. Then install the lower hinge onto the left
side of the lower frame with two screws.
8. Position the door in place making sure the door seats onto the lower hinge.
9. Align the door in the closed position secure the upper hinge in the top fame on
left side with two screws. Remember do not tighten the two screws until the top
of the door is levelled with the top of the fridge.
10. Install the upper hinge cover on the upper hinge
For Customer Services, Spare Parts & Manufacturer's Guarantee Information please call 01204 664 084

Door Reversal

two screws to the rear of the unit and lifting the top cover.
-6-
1
2
4
8
5
6