Advertisement
GPS – MT4100 Installation Guide
Power
The power cable is a keyed cable and will only fit into the device one way.
The device has an input voltage range of 9 – 32 V DC. This allows the device to be used on
both 12V and 24V vehicles per SEA specifications.
Connect the power (RED wire) and ground (Black wire) of the device to the vehicle battery
leads. Connect the ignition (BLUE wire) to the vehicle ignition. The device will always
remain ON.
The device will be non-operational when the input voltage and current requirements are not
met (vehicle battery drains).
The MT 4100 case includes molded anchor points for mounting as shown in the figure above (facing
skyward).
Device Mounting
Please note while the devices needs to be installed inside the vehicle. The device will have optimal
functionality when there is as little as possible between the device and the sky.
Areas to consider when mounting your device:
Above the air vent
Above the instrument cluster
Above the glove box
DQ Technologies, Inc., phone: 512.248.8324 ‐ fax: 757.886.0831 ‐ www.dqtech.com
Advertisement
