Power; Accelerometer; Gsm Radio - Enfora MT 3050 User Manual

The following table describes the LED operation.
OBD The OBD LED will flash at a fast rate when the unit is first connected to the OBD port for power. Once a protocol is
(Red) discovered through the OBD port, the LED will flash at a slow rate.
NETWORK The NETWORK LED will flash at a fast rate when the unit is finding cellular coverage. Once cellular coverage is found, the
(Green) LED shall flash at a slow rate.
GPS The GPS LED will flash at a fast rate when the unit is acquiring a satellite fix. Once a fix is acquired, the LED will flash at
(Blue) a slow rate.
Table: 6 - MT 3050 LEDs

2.3 Power

The MT 3050 requires 9-16 VDC minimum 2 amps input power. Pin 16 on the 16-Pin IO connector is the
positive power input, and pin 4 and 5 is the ground. This device contains a battery. This battery is not to be
removed or replaced by the user. Please dispose of this device according to local recycling laws.

2.4 Accelerometer

The three-axis digital accelerometer provides the following features:
Motion alert (towing alert)
l
Driver behavior reporting
l
Rapid acceleration
l
Harsh braking
l
Configurable thresholds
l
Range settings
l
Mode (Normal, Sleep, Wakeup)
l
Wakeup pause (20 to 2560 msec)
l
Sample Rate (0-25 per second)
l
Filter Coefficient and Filter Bandwidth
l
Device Orientation Setup
l

2.5 GSM Radio

The MT 3050 (GSM2378) contains a quad-band (850/900/1800/1900 MHz) GSM radio.
Class 4 (2W@850/900 MHz)
l
Class 1 (1W@1800/1900 MHz)
l
MT 3050 LEDs
7