Advertisement
GPS – MT4100 Installation Guide
Do not apply excessive force in the middle of the device as this may damage the device.
If using rigid mounting hardware, apply pressure only to the ends of the device.
Limit the mounting pressure only to the amount needed to secure the device.
MT4100 LED
The MT 4100 has three LEDs on its front panel
PWR
This LED indicates power to the GPS module. LED is on less than 1 second after powered on and the GPS module is
operational. This LED is off when powered off or when the MT 4100 enters Low‐Power Sleep mode.
GPS
his LED indicates GPS fix status. The LED remains off when it receives invalid GPS data. The LED remains on when
T
it receives valid GPS data.
Registration
:
his LED indicates network registration status. If this LED stays off, this indicates that the device is not attempting
T
to register to the network. If the LED blinks, it indicates that the device is trying to connect to the network. If the
LED is always on, this indicates that the device has connected to the network.
DQ Technologies, Inc., phone: 512.248.8324 ‐ fax: 757.886.0831 ‐ www.dqtech.com
Advertisement
