Tongue - RHINO FN180 Operator's Manual

ASSEMBLY:
7. Place one new friction disc against the yoke flange, then place the hub flange against the friction disc, then
place the other friction disc against the hug flange.
8. Add the pressure plate so that the flat surface rests on the friction disc.
9. Add the disc spring so that the spring inside diameter contacts the fins of the pressure plate, making sure
the spring is centered.
10.Install the bolts then assemble the spacers on the bolts.
11. Assemble the compression plate then install the nuts on the bolts.
12.Tighten all the bolts on the outside diameter of the clutch until the spacers cannot be rotated by hand then
back off until the spacers rotate by hand.
ADJUSTMENT
1. Tighten all the bolts on the outside diameter of the clutch until the spacers cannot be rotated by hand then
back off until the spacers rotate by hand.
MOUNTING
1. Mount and clamp the clutch hub onto the implement input shaft. Make sure the grooves of the shaft and
clutch line up.
2. Reinstall any shielding that was moved or removed.
3. The clutch must be run-in before it is used. Follow the instructions for run-in of the clutch.

Tongue

The Tongue Hitch Pins attach the Tongue to the Center Section and should be checked for signs of wear or
cracking. Replace as needed. The Drawbar 1" Bolt fastens the mower to the tractor Drawbar. When the mower
is unhitched and this 1" Bolt is removed, examine for signs of cracking or wear. Replace the Drawbar 1" Bolt at
first sign of either problem. FIGURE Op-1155
FN180/FN120 07/12
© 2012 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-25