Automatic Addressing - LG Multi V Plus II System Installation Manual

Automatic Addressing

• The address of indoor units would be set by auto
addressing
1) Wait for 3 minutes after applying power supply
(master and sub outdoor unit, indoor unit).
2) Press the switch of the outdoor unit (SW02V) for 5
seconds.
3) A "88" is indicated on 7-segment LED of the out-
door unit PCB.
4) For completing addressing, 2~7 minutes are
required depending on numbers of indoor unit con-
nection set.
5) Numbers of indoor unit connection set whose
addressing is completed are indicated for 30sec-
onds on 7-segment LED of the outdoor unit PCB.
6) After completing addressing, address of each
indoor unit is indicated on the wired remote control
display window. (CH01, CH02, CH03, .............
CH06: Indicated as numbers of indoor unit connec-
tion set.)
CAUTION
- In replacement of the indoor unit PCB, always perform auto address setting again.
If power supply is not applied to the indoor unit, operation error occurs.
Auto addressing is only possible on the main PCB
Auto addressing has to be performed after 3 minutes to improve communication.
N The Procedure of Automatic Addressing
Power On
Waiting 3 minutes
Press SW02V for 5 sec.
7-segment LED
Don't Press SW02V
Waiting about 2~7 minutes
7-segment LED
= 88
YES
OK
Auto addressing start
= 88
• Auto addressing setting end
Numbers of indoor unit connection set whose
addressing is completed are indicated for 30seconds
on 7-segment LED after completing setting
NO
Indoor address number is displayed on wired remote control or
indoor unit display window. It is not an error message, will
disappeared when on/off button is pressed on remote control
ex) Display of 01, 02, ..., 15 means connection of 15 indoor
units and auto addressing is completed normally.
Electrical Wiring
SW01B SW02B
(DIP S/W) (DIP S/W)
Check the connections
of communication line
Installation Manual 69
7 - Segment
SW02V
Auto addressing
SW01V
Data confirm