Auto Restart Function - Mitsubishi Electric Mr.SLIM MSH24WN Operating Instructions Manual

PREPARATION BEFORE OPERA

Auto restart function

■
This model is equipped with an auto restart function. If you do not want to use this
function, please consult the service representative because the setting of the unit
needs to be changed.
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and
the fan speed are stored in the memory. If a power failure occurs or the main power is turned off during
operation, "Auto restart function" sets automatically to start operating in the same mode as the one set with
the remote controller just before the shutoff of the main power. (Refer to page 7 for details.)
Breaker for the air conditioner
■
Turn the breaker on.
Remote controller (How to set the batteries and the current time)
1
Remove the front lid and insert bat-
teries. Then reattach the front lid.
Insert the minus pole of the batteries first.
Check if the polarity of the batteries is correct.
2
Press the RESET button.
Press using
a thin stick.
■ If the RESET button is not pressed, the remote control-
ler may not operate correctly.
6
3
Insert the minus
4
pole of the
batteries first.
■ Each time the
5
Press the CLOCK set button.
Press using
a thin stick.
HR.
Press the and
(TIME SET buttons) to set the cur-
rent time.
FAN
I FEEL COOL
VANE
HEAT DRY
MODE WIDE VANE
LONG MIN.
RESET CLOCK
HR.
button is pressed, the set time in-
creases by 1 hour, and each time the
pressed, the set time increases by 1 minute.
Press the CLOCK set button again
and close the front lid.
MIN.
buttons
STOP
START
HR.
MIN.
button is