Advertisement
Important Safety Instructions
IMPORTANT:
Your KODAK EKTAGRAPHIC III AFT Projector is supplied with a 3-wire grounding
power cord to comply with UL122 and CSA222 Safety Electronics Standards.
We urge you to provide a permanent, properly installed 3-wire receptacle as the source
of power for this projector. Your projector is designed to operate with 110 to 125 volts,
60 Hz current only. Incorrect voltage could cause the projector to malfunction. Inputs in
excess of
125 volts will adversely affect lamp life.
When using your projector, always follow these basic safety precautions:
1. Read and understand all instructions before using this equipment.
2. Operate this projector with 110-125 volt 60 Hz current only. Incorrect voltage can
cause projector malfunction.
3. Close supervision is necessary when any appliance is used by or near children,
or others who may not understand the need for these precautions. Do not leave
the projector unattended during use.
4. Be careful not to touch hot parts. For lamp replacement, allow the module to
cool before touching the lamp and the surrounding area. Do not place the lamp
module on heat-sensitive surfaces.
5. Do not operate your projector if the power cord is damaged or if the projector
has been dropped or damaged.
6. Position the cord so that it is not tripped over. pulled, or placed in contact with
hot surfaces.
7. If an extension cord is necessary, use a cord with a current rating at least equal
to that of the projector. Cords rated for less amperage than the projector may
overheat.
8. Always unplug the projector from the electrical outlet before cleaning and
servicing and when not in use.
9. Allow the projector to cool before storing.
10. Do not immerse this equipment in water or other liquids.
11. Do not disassemble this projector. Use a qualified service technician when
service or repair is required. Incorrect reassemble can cause electric shock the
next time the projector is used.
12. Use only safety electrical low-voltage (SELV) devices.
13. The use of an accessory attachment not recommended by the manufacturer
may increase the risk of damage.
14. Keep the airflow vents unobstructed.
Advertisement
