Important Safety Instructions - Kodak Ektalite 1000 Instruction Manual

Important Safety Instructions

When operating your projector, always follow basic safety precautions:
1. Read and understand all instructions before operating your projector.
2. Before you switch on your projector, ensure that the mains voltage input is correct or is
correctly adjusted for Models 2000, 1500, and 1000! Incorrect voltage can lead to malfunction
in the projector.
3. Close supervision is necessary when any appliance is used by or near children, or others who
may not understand the need for these precautions. Do not leave the projector unattended
during use.
4. Be careful not to touch hot parts. For lamp replacement, allow the module to cool before
touching the lamp. Do not place the lamp module on heat-sensitive surfaces.
5. Do not operate your projector if the cord is damaged or if the projector has been dropped or
damaged (see "How to Obtain Service" on page 81).
6. Position the cord so that it is not tripped over, pulled, or placed in contact with hot surfaces.
7. If an extension cord is necessary, use a cord with a current rating at least equal to that of the
projector. Cords rated for less amperage than the projector may overheat.
8. Always unplug the projector from the electrical outlet before cleaning and servicing and when
it is not in use.
9. Allow the project to cool before storing.
10. Do not immerse this equipment in water or other liquids.
11. Do not disassemble this projector. Use a qualified service technician when service or repair is
required. Incorrect reassembly can cause electric shock the next time the projector is used.
12. Use only safety electrical low-voltage (SELV) devices.
13. The use of an accessory attachment not recommended by the manufacturer may increase risk
of damage.
14. Connect this projector to a grounded outlet.
15. Keep the air-flow vents unobstructed.
Electrical Approvals and CE Mark
This projector complies with International Safety requirements of IEC 335-/-2-56 and bears the
following safety marks:
• CE
• SGS Australian Standard
44
• TÜV
• VDE (Pending)
KODAK EKTALITE Slide Projectors