Table of Contents
Advertisement
Galaxy A16F-R2431 Installation and Hardware Reference Manual
The MUTE button silences the alarm temporarily until the next controller
event occurs.
The definitions of LEDs on the panel are given in Table 4-2 below.
Name
PWR (Power)
BUSY
ATTEN
(Attention)
During the power-on process, the ATTEN LED will light up steadily.
Once the subsystem successfully boots up with no faults, the ATTEN LED
is turned off.
4.4.3
Drive Tray LEDs
Two (2) LED indicators are located on the right side of each drive tray. (See
Figure 4-4) Refer to Table 4-3 for the LED definitions. When notified by a
drive failure message, you should check the drive tray indicators to find the
correct location of the failed drive. Replacing the wrong drive can fatally
fail a logical array.
4-8
Figure 4-3: LCD Keypad Panel
Color
Status
ON indicates that power is supplied to the
subsystem.
Blue
OFF indicates that no power is supplied to
the subsystem or the subsystem/RAID
controller has failed.
FLASHING indicates that there is active
traffic on the host/drive channels.
White
OFF indicates that there is no activity on the
host/drive channels.
ON indicates that a component failure/status
event has occurred.
Red
OFF indicates that the subsystem and all its
components are operating correctly.
Table 4-2: LCD Panel LED Definitions
NOTE:
Status-indicating LEDs
Advertisement
Table of Contents
