Husqvarna C42C 954 04 05-09 Owner's Manual page 8

For Parts Call K&T 606-678-9623 or 606-561-4983
4
MOUNTING TO TRACTOR (See Fig. 4)
Use Hardware - - GROUP "C"
NOTE: For ease of assembly, you may wish to obtain the
as sis tance of another person for mounting assembly to
tractor.
1. Raise seat on tractor to allow assembly to be
mounted.
2. With cover closed, lift assembly and place support
post inside mounting bracket. Allow assembly to rest
on lanced tabs of mounting bracket.
3. Line up holes in mounting bracket with holes in support
post and insert bracket support pin. Secure with retainer
spring.
4. Unlatch and open cover.
5. Install the three (3) tubing end caps onto container
support.
6. Tap each end cap onto container support tubes to seat
securely.
BRACKET
SUPPORT PIN
END CAP
SUPPORT POST
LANCED TABS
MOUNTING
BRACKET
FIG. 4
5
1. Place bottom half inside of top half, as shown.
2. Place one foot inside bottom half and lift top half to
3. Press halves tightly together while lifting top to lock
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES
ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN
IN INSET.
4. Repeat for other containers.
COVER ASSEMBLY
RETAINER
SPRING
CONTAINER
TOP HALF
CONTAINER
BOTTOM
HALF
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tain er and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
8
www.mymowerparts.com
CONTAINER ASSEMBLY (See Fig. 5)
No hardware required
meet bottom half.
into place as shown.
CONTAINER
BOTTOM HALF
FIG. 5
CONTAINER
TOP HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
LOCKING
TAB
pe qu om me
is pro ba g fre a rec
er eck e on ly
tain n. Ch Us
les s con atio ge d.
r un tier da ior ma
NG mo we d de d or
NI te ar an cke
W AR t op to era we en cra tain er.
no bje ct ce wh t con
Do ssu pla em en
rlyi tly. Re lac
en ed rep
nd