Configuring A T1 Port As A Co Line; Configuring A T1 Port For Did Or Dnis - Telecor VS1 Installation, Configuration & Operating Manual

Configuring a T1 Port as a CO Line

To configure a T1 port as a CO line, complete the following steps.
1. Using the VS1 Editor configuration program, click the Port Configurations pane.
2. In the Port Configurations pane, select the configuration you want to change. (For example,
the DAY configuration).
3. Select the CO port you want to configure.
4. Beginning at Port 97 (for one T1 Interface Card) or Port 65 (for two T1 Interface Cards), every
fourth port is reserved, and the others are unassigned. The reserved ports are a function of the
T1 interface. You must configure each active channel on the T1 Interface Card as a CO line.
TI port configured as
CO line
5. Select the unassigned port that you want to assign as a CO port, and then click Type. The Port
Type window appears.
6. Select CO Line, and then click OK to return to the Port Configuration pane.
7. Repeat steps 5 and 6 for each port you want to set up as a CO Line.
8. To set up other configurations, repeat steps 2 through 7.
9. After all ports are assigned as CO Lines, click the Save button in the toolbar to save your
changes.

Configuring a T1 Port for DID or DNIS

1. With a configuration selected in the Port Configurations pane, select a T1 port that you have
assigned as a CO Line.
Note If you have not assigned a port type to the port you selected, a warning message appears
telling you to first assign a port type.
2. Enter the following information in the corresponding text boxes:
•
Description: Enter a description for the T1 line.
•
Extension: Enter an extension. (Enter –1 if no extension is assigned)
248 Reference