Table of Contents
Advertisement
12 VDC
The Rear Panel consists of a MAIN POWER and CONTROL CABLE connector, TO
RECEIVER and TO MOUNT F-Connectors. The Nomad SD Controller differs from the
Nomad SD2 in that the SD Memory Card Slot is located in the rear of the unit between the
Control Connector (9 pin) and the "To Receiver" F-type connector.
CONNECTIONS
12 VDC: Provides +/- 12 volt DC input power for Controller and
Mount operation.
Control Cable: Sends +/- 12 volt DC power to the Mount motors and
receives positioning information from the dish.
To Receiver: This cable routes the TV signal to the Satellite Receiver (see the label on
the bottom of the Controller.)
To Mount: This cable routes to the Roof Mount to provide LNB power (see the label on
the bottom of the Controller.)
NOTE: For
B-Band Converter (BBC), install it before the Controller.
For
controller.
REAR VIEW
Control Cable
DirecTV
5 LNB Slim Line High Definition receivers that require a
Dish Network
receivers that use a Separator, install it after the
6
To Receiver To Mount
Advertisement
Table of Contents
