D-Link AirPremier DWL-1000AP+ Manual page 27

Troubleshooting (continued)
2. The wireless client cannot access the Internet in the Infrastructure
mode.
Make sure the wireless client is associated and joined with the
correct Access Point. To check this connection: Right-click on
the Local Area Connection icon in the taskbar> select View
Available Wireless Networks. The Connect to Wireless
Network screen will appear. Please make sure you have selected
the correct available network, as shown in the illustrations below.
Check that the IP Address assigned to the wireless adapter is within
the same IP Address range as the access point and gateway.
Since the DWL-1000AP+ has an IP Address of 192.168.0.50,
wireless adapters must have an IP Address in the same range,
e.g., 192.168.0.x. Each device must have a unique IP Address; no
two devices may have the same IP Address. The subnet mask
must be the same for all the computers on the network.) To check
the IP Address assigned to the wireless adapter, double-click on
the Local Area Connection icon in the taskbar > select the
Support tab and the IP Address will be displayed. (Please refer to
Checking the IP Address in the Networking Basics section of
this manual.)
If it is necessary to assign a Static IP Address to the wireless
adapter, please refer to the instructions on the following page.
27