Installing The Microphone Unit - Kenwood DPX405BT Quick Start Manual

Removing the Unit
1
Remove the trim plate by referring to the removal
procedure in the section <Removing the trim
plate>.
2
Insert the two extraction keys (Accessory 3) deeply
into the slots on each side, as shown.
3
Lower the extraction key toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
¤
• Be careful to avoid injury from the catch pins on the
extraction key.
4
Pull the unit all the way out with your hands, being
careful not to drop it.
Accessory 3
DPX405BT only
Installing the Microphone
unit
1
Check the installation position of the microphone
(Accessory 4).
2
Remove oil and other dirt from the installation
surface.
3
Install the microphone.
4
Lay the cable up to the unit with it secured at
several positions using tape or the like.
⁄
• Install the microphone as far as possible from the
cell-phone.
Accessory 4
Fix a cable with a commercial item of tape.
Peel off the release coated
paper of double-face adhe-
sive tape to secure the
microphone on the place
shown above.
Adjust the direction of the
microphone to the driver.
English | 13