Installing The Microphone Unit - Kenwood DDX4038BT Installation Manual

Installation on Toyota, Nissan or
Mitsubishi Car using Brackets
Accessory 6 (M5x6mm)
or Accessory 7 (M5x7mm)
Accessory 6 (M5x6mm)
or Accessory 7 (M5x7mm)

Installing the Microphone Unit

(DDX4038BT/DDX4038BTM only)
1
Check the installation position of the
microphone (accessory 8).
2
Remove oil and other dirt from the
Car Bracket
installation surface.
3
Install the microphone.
4
Wire the microphone cable up to the unit
with it secured at several positions using
tape or the like.
⁄
• Install the microphone as far as possible from the
cell-phone.
Fix a cable with a commercial item of tape.
Peel the release coated paper of double-face
adhesive tape to fix on the place shown above.
Adjust the direction of the microphone to the driver.
Accessory 8
7
English