Table of Contents
Advertisement
Operation
Starting up the projector
1.
Connect the power using the power cord. The Power indicator turns into orange.
2.
Press
control to start the projector. The Power
indicator lights green when the projector is
on.
The start up procedure takes several seconds.
In the later stage of start up, a startup logo is
projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
3.
If the projector is activated for the first time, select your OSD language following the
onscreen instructions.
4.
If you are prompted for a password, press the
arrow keys to enter a six digit password. See
"Utilizing the password function" on page 31
for details.
5.
Switch all of the connected equipment on.
6.
The projector will display the home screen.
If the frequency/resolution of the input signal exceeds
the projector's operating range, you will see the
message 'Out of Range' displayed on a blank screen.
Please change to an input signal which is compatible with the projector's resolution or set the
input signal to a lower setting. See
Power on the projector or remote
I
I
"Timing chart" on page 84
for details.
Operation 27
Advertisement
Table of Contents
