Switching Hdd / Dvd / Vhs Mode - Toshiba RDXV49DTKF Owner's Manual

E3TK0FD_EN.book Page 12 Monday, March 9, 2009 10:00 AM
Installing Batteries in the Remote
Control
Install two R6 (AA) batteries (supplied) into the remote
control, carefully match with the polarity indicated inside the
battery compartment.
1
Caution
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used for a
month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
About the Remote Control
• Make sure there is no obstacle between the remote control
and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
ON/STANDBY
7 m (30°)
• The maximum operable range as follows:
Line of sight:
Either side of centre: approximately 7 m within 30 degrees
• Remote control operation may become unreliable if the
remote control sensor of the unit is being exposed by the
strong sunlight or fluorescent light.
• Remote controls for different devices can interfere with each
other. Be careful when using remote controls for other
equipment located close to the unit.
• Replace the batteries when the operating range of the
remote control reduces.
12
EN
Downloaded From Disc-Player.com Toshiba Manuals
2 3
OPEN/CLOSE
VCR REC DUBBING VCR HDD DVD HDD DVD
Within
7 m 7 m (30°)
about 7 m
approximately 7 m

Switching HDD / DVD / VHS mode

Because this unit is a combination of an HDD, a DVD and a
VHS recorder, you must select which component you want to
operate first.
indicator
VCR HDD DVD
button
SELECT
OPEN/CLOSE
ON/STANDBY
VCR REC DUBBING DUBBING VCR HDD DVD HDD HDD DVD DVD
VCR DVD
REC PROGRAM VCR HDD DVD REC
HDD DVD
VCR SELECT HDD/DVD
Device select indicators
VCR button
HDD button
DVD button
HDD
Press [HDD] on the remote control or the front panel.
(Verify that the HDD indicator is lit in blue.)
DVD
Press [DVD] on the remote control or the front panel.
(Verify that the DVD indicator is lit in green.)
VHS
Press [VCR] on the remote control or the front panel.
(Verify that the VCR indicator is lit in orange.)
USB DV IN