Installing Batteries In The Remote Control; Switching Dvd / Vhs Mode - Toshiba DVR70DTKF2 Owner's Manual

Dvd / video cassette recorder
Table of Contents

Advertisement

E9TK2FD_EN.book Page 12 Wednesday, July 29, 2009 12:16 PM
Installing Batteries in the Remote
Control
Install two R6 (AA) batteries (supplied) into the remote
control, carefully match with the polarity indicated inside the
battery compartment.
1
2
Caution
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used for a
month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
About the Remote Control
• Make sure there is no obstacle between the remote control
and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
ON/STANDBY
7 m (30°)
7 m
• The maximum operable range as follows:
Line of sight:
approximately 7 m
Either side of centre: approximately 7 m within 30 degrees
• Remote control operation may become unreliable if the
remote control sensor of the unit is being exposed by the
strong sunlight or fluorescent light.
• Remote controls for different devices can interfere with each
other. Be careful when using remote controls for other
equipment located close to the unit.
• Replace the batteries when the operating range of the
remote control reduces.
12
EN
3
OPEN/CLOSE
VCR
DVD
Within
7 m (30°)
about 7 m

Switching DVD / VHS mode

You must select which component you want to operate first.
Press [DVD] or [VCR] on the remote control or the front
panel.
indicator
VCR
SELECT
button
OPEN/CLOSE
ON/STANDBY
VCR
DVD
VCR
DVD
REC
PROGRAM
DUBBING
SELECT
VCR
Device select indicators
VCR button
DVD button
DVD
Press [DVD] on the remote control.
VHS
Press [VCR] on the remote control.
Note
• You can also press [SELECT] on the front panel to switch
between DVD and VHS mode.
DVD
REC
DVD
USB
DV IN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents