Lens Assembly Installation; Lens Assembly Replacement; Care Of Glass - Napoleon GDS26N Installation And Operating Instructions Manual

10.1.2

LENS ASSEMBLY INSTALLATION

Remove the door from the fi rebox.
A.
Run the wires up through the lens hole.
B.
Align key hole with lens assembly.
C.
Snap into place.
D.
Replace light shields, attach the wires and replace the door to the fi rebox.
E.
10.1.3

LENS ASSEMBLY REPLACEMENT

Remove the front door and top shield from the fi rebox.
A.
Compress the retainer fi ns in with a screw driver while pressing fi rmly on
B.
the top of the light assembly.
Once all the retainer fi ns are pushed in the lens assembly will snap out of
C.
place.

10.2 CARE OF GLASS

DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the fi rst 10 hours of operation with a
recommended fi replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
KEY HOLE
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
5.1
W415-0827 / D / 08.10.12
41