Care Of Glass; Night Light™ Replacement; Bulb Replacement; Lense Assembly Installation - Napoleon Vittoria GD19P-2 Installation And Operation Manual

11.3

care of glass

WARNING
!
• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
Buff lightly with a clean dry soft cloth to remove accumulated dust or fi ngerprints. Clean both sides of the glass
after the fi rst 10 hours of operation with an ammonia-free glass cleaner.
note:
Vinegar-based glass cleaners have demonstrated an ability to provide a clean, streak free glass surface.
Thereafter, clean as required. If the glass is not kept clean permanent discoloration and / or blemishes may
result. Contact you local authorized dealer / distributor for complete cleaning instructions.
Razor blades, steel wool, or other metallic objects must not be used on both surfaces of the glass. Doing so
can remove a thin layer of metal from the razor blades, steel wool, or other metallic objects that may then be
deposited onto the coating. This can result in a discoloured stain or scratch-like mark. More importantly, this can
scratch the glass surface, thereby reducing its strength.
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
Contact your local authorized dealer / distributor for complete cleaning instructions.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact you local authorized dealer / distributor for
replacement parts. DO NOT SUBSTITUTE MATERIALS.
This appliance is factory equipped with 5mm ceramic glass. Use only replacement parts as supplied by the
appliance manufacturer. DO NOT SUBSTITUTE MATERIALS.
11.4 night light™ replacement

11.4.1 bulb replacement

The GD19-2 comes equipped with our "Night Light™". In the event the lamp or lens needs to be replaced, follow these
instructions:
A. Turn off all electrical supply.
B. Remove the safety barrier, front and door from the firebox.
C. Unscrew the lens cover making sure the washer stays in place.
note:
Do not handle the lamp (bulb) with care fingers. Protect with a clean, dry cloth.
D. The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts only (W387-0009), as lamp and
lens are special "high temperature" products.
E. Replace lens with gasket, lens covers, attach wires to quick connects and replace the safety barrier and door
when finished.
note:
The firebox must be sealed.
When re-assembling the light assembly, care must be taken. "Light Leakage" from above the cast doors
may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.

11.4.2 lense assembly installation

A. Remove the safety barrier and door from the firebox.
B. Run the wires up through the lens hole.
C. Align key hole with lens assembly.
D. Snap into place.
E. Replace light shields, attach the wires and replace the door and safety barrier
to the firebox.
maintenance
5.1A
5.1.3
KEY HOLE
W415-2355 / A / 12.09.20
EN
51