Port Advanced Setting - Belkin BoB User Manual

Chapter 5 : Advanced Setup
BoB Advanced Setup Method
TM

Port Advanced Setting

Configure advanced VoIP settings on this page then click 'SAVE SETTINGS' .
Volume Gain Control
Use this option to adjust the volume of calls made
through VoIP.
VAD
Voice Activation Detection. VAD is designed to
conserve bandwidth by halting transmission of voice
packets until it has detected a noise either by voice
or outside noise. The downside to this is it may miss
some packets due to a slight delay in the transmission
of packets. Disable this if you are experiencing issues
with phone system menus, faxing over IP, etc.
Caller ID Mode
Use DTMF Caller ID Mode. Enabling this option enabled
the Dual Tone, Multi-Frequency (touch tone) mode for
Caller ID
Set the Phone Number and Connection Type on this page.
Inter Digit Delay
This is the delay time before processing the dialled
digits This will delay the VoIP unit dial the telephone
number after the digits have been entered.
T.38 Mode
38 is the standard for sending faxes over IP networks.
Enable this option for Faxing over IP.
Dial Tone(Hz)
Adjust the pitch of the VoIP dial tone. Dialling Plans
Configure the VoIP dialling plans on this page, and
click 'SAVE SETTINGS' .
Page 47