Hdmi Out Connector; Hdmi In Connector; 3.5Mm Ir Out - BrightSign XD230 Hardware Manual

HDMI Out Connector

The HDMI-out connector is used to send digital video and audio to HDMI-enabled sink devices. The following table
illustrates the pinout of the HDMI connector:
pin
1 TX2p
3 TX2n
5 Ground
7 TX0p
9 TX0n
11 Ground
13 CEC
15 DDC SCL
17 Ground
19 HDP (Hot Plug Detect)

HDMI In Connector

The HDMI In accepts inputs of up to 1920x1080@60p, with 24-bits RGB. The signaling conforms to the DVI 1.0, HDMI
1.4, and HDCP 1.2 standards. The HDMI signaling has CEC (but no ARC or HEC) functionality. The CEC channel is
electrically coupled to the corresponding signal on the HDMI output, and the CEC commands will pass through players
even when they do not have power.

3.5mm IR Out

The IR blaster generates a space-encoded (NEC) signal. The two transported bit values of the NEC signal (0 and 1) are
encoded using differing lengths of low-time IR pulses.
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2012
Description pin
10
12
14
16
18
BrightSign XD230, XD1030, XD1230
Description
2 Ground
4 TX1p
6 TX1n
8 Ground
TXCp
TXCn
NC
DDC SDA
+5V DDC
11