Brave EZ Split Owner/Operator And Safety Manual page 7

Assembly Instructions
4. Slide cylinder and push plate assembly (1)
towards the engine until the trunnion pins
on the side of the cylinder fit into the slots
of the cylinder mounting bracket (2).
5. Install two retaining plates (3) using four
5/16 x 3/4 inch long hex bolts (4) and lock-
nuts (5). Tighten the nuts securely using
the two 1/2 inch wrenches.
6. Slide the hose clamp onto low pressure
hose (1). Push the hose onto the fitting
and securely tighten the hose clamp with a
flathead screwdriver.
7. Thread high pressure hose (2) onto the
control valve fitting. Tighten the hose
using a crescent wrench.
Brave Products, Inc.
1
2
5
3
4
800-350-8739
10
8. Attach the valve control handle to the
valve. First, install clevis pin and hairpin
clip (1) through the bottom hole on the
valve.
Next, insert the forked end of handle (2)
over pin (1).
Finally, align the hole in the handle with the
top hole in the valve and insert clevis pin
and hairpin clip (3).
EZ-25
9. Use the Phillips head screwdriver and
remove the brackets that hold the log split-
ter to the board.
10. Install the two tires.
Raise one side of the log splitter and
install a tire onto the axle. Install a push
nut and tap it in place with a hammer.
Repeat the process for the other wheel.
EZ-26
Note: Placing a socket over the push nut and
tapping on the socket will make it easier to
install the push nut.
11. Unfold the handle from under the rail.
12. Attach front leg (1) to rail (2) using two
5/16 x 1 inch hex bolts and locknuts. One
bolt/nut is in the parts box; the other is
attached to the rail and the shipping
bracket.
13. Your EZ Split log splitter is now fully
assembled.
800-350-8739
Assembly Instructions
Brave Products, Inc.
11