Marine PC MPC-MLR User Manual page 26

TSHARC Installation
If you need to cancel this driver installation at any time, select the Cancel button on
the driver installation dialog screen.
caution!
Select Controller
1. The TSHARC Driver is a 12-bit controller; the radio button is selected by default
Note: A PS/2 controller interface is not available.
2. Select the controller interface matching the cable
used to install the MPC-MLR
3. Select the Autodetect button if installing the Touch
Screen through a RS-232 (serial)
interface
. There are two options for RS-232 installation: Auto-
detect and Manual. Manual instructions are found in
section Manual RS-232 Controller Set-up
5. If connecting through a USB interface, select the USB
radio button
6. Select Next
. Following installation, select Finish, and
8. Reboot the computer when prompted.
Autodetect RS-232 Controller Set-up
1. Select the Autodetect button
2. The "AutoDetect Serial" dialog box lists the detected
RS-232 controller information. Select OK
3. "Installing Touch Screen Driver" text box pops up,
indicating the progress of the installation
. Following installation, select Finish, and
5. Reboot the computer when prompted.
26
MPC-MLR-UM(A) 10/2009
1. At the Welcome screen, select Next to go to the
Software License Agreement (EULA)
2. After reading the EULA, if in agreement, check
the box "I accept all of the terms..."
3. Select Next.
Note: Any unlawful use of the TSHARC driver is a strict
violation of the United States and International copyright
laws. Using a TSHARC driver with any third party Touch
Screen is strictly prohibited.