Hide-A-Bed Sofa; Sofa Bed; Bedroom Door Latch; Day/Night Shade - Thor Motor Coach tuscany 2013 Owner's Manual

Chapter 8 - Interior Systems

HIDE-A-BED SOFA

SOFA BED

BEDROOM DOOR &
LATCH

DAY/NIGHT SHADE

A/C & FURNACE
THERMOSTAT
WATER HEATER
SWITCH
KITCHEN CABINETS
52
• If the system squeaks or makes any noises, it is permissible to apply a think coat of
lightweight oil to the drive shaft and roller areas. Remove any excess oil so that dirt
and debris cannot build up.
The hide-a-bed sofa is very similar to the one that you would find in a home. To open
into a bed, and pull off all cushions, pull the handle located on the top of the mattress up
and out. The bed will pull out to reach a full bed size, so check to make sure that there
is adequate room before opening the bed. Use the bed as you would a normal bed. To
replace the bed back to the sofa position, reverse the procedure and push the bed both
in and away from the front of the sofa.
Some Thor Motor Coach models may have a sofa bed. To convert the sofa into a bed,
pull bench out and up. To convert back into a sofa, reverse procedure.
Some Thor Motor Coach bedroom doors slide conveniently out of the way beside the
wall. Thor Motor Coach provides a vinyl travel strap or a slide latch to secure the door
while the motorhome is in motion. The door latch is a bayonet type, which is engaged
by turning the handle. Some models have an accordion type door which latches to the
wall when the door is closed.
Your motorhome may have day/night shades, which are designed to serve a dual
purpose. For daytime use, pull down the bottom half of the light colored shade which
allows light to enter the motorhome while affording some privacy. For night use, or to
shut light out and increase your privacy, pull the top, darker part of the shade down.
For your comfort we have 13,500 BTU Carrier air conditioners some with heat pumps.
There is a remote control for the air conditioners for your convenience. This remote also
controls the furnace. Simply point to the A/C, press heat on the remote and set your
degree of comfort level.
The hot water heater start switch is located on the wall in the galley, bathroom, or monitor
panel area. The light illuminates when the switch is turned on. The light goes off when
the burner is on and the water is heating. If the light comes back on, the burner is not yet
lit. It may take several tries to light the water heater burner. When the element is turned
on the red light will glow. Be sure the tank is full of water before using.
For your convenience, there is plenty of storage above and around the range area
for canned goods, kitchen utensils, etc. Please ensure that the doors are closed and