Troubleshooting And Error Code; Troubleshooting; Error Code - Samsung ME83D Owner's Instructions & Cooking Manual

troubleshooting and error code

TROUBLESHOOTING

If you have any of the problems listed below try the solutions given.
This is normal.
• Condensation inside the oven.
• Air flow around the door and outer casing.
• Light reflection around the door and outer casing.
• Steam escaping from around the door or vents.
The oven does not start when you press the ( ) button.
• Is the door completely closed?
The food is not cooked at all.
• Have you set the timer correctly and/or pressed the ( ) button?
• Is the door closed?
• Have you overloaded the electric circuit and caused a fuse to blow or a
breaker to be triggered?
The food is either overcooked or undercooked.
• Was the appropriate cooking length set for the type of food?
• Was an appropriate power level chosen?
Sparking and cracking occur inside the oven (arcing).
• Have you used a dish with metal trimmings?
• Have you left a fork or other metal utensil inside the oven?
• Is aluminum foil too close to the inside walls?
The light bulb is not working.
• The Light bulb should not be replaced in person for safety reasons.
Please contact nearest authorised Samsung customer care, to arrange
for a qualified engineer to replace the bulb.
The oven causes interference with radios or televisions.
• Slight interference may be observed on televisions or radios when the
oven is operating. This is normal. To solve this problem, install the oven
away from televisions, radios and aerials.
• If interference is detected by the oven's microprocessor, the display
may be reset. To solve this problem, disconnect the power plug and
reconnect it. Reset the time.
ME83D-1W_XSA_DE68-04225C_EN.indd 19
If the above guidelines do not enable you to solve the problem, then
contact your local SAMSUNG customer service centre.
Please have the following information read.
• The model and serial numbers, normally printed on the rear of the
oven
• Your warranty details
• A clear description of the problem
Then contact your local dealer or SAMSUNG aftersales service.

ERROR CODE

"SE" message indicates.
• The "SE" message is Clean the keys and check if there is water on
the surface around key. Turn off the microwave oven and try setting
again. If it occurs again, call your local SAMSUNG Customer Care
Centre.
English - 19
04/10/2013 18:57:37