Canon Networked Multi-Projection Set Up And Instructions Manual page 67

Projection type
Sound
Nickname
Multicast address
Completing Software Projection Settings
Normal : Although some windows cannot be
projected, the cursor on the computer
monitor will not flash.
Advanced : Most windows can be projected, but the
cursor on the computer monitor will flash.
(Only the cursor on the computer monitor
will flash, not the cursor in projected
images.)
Specify audio transfer. This item is not displayed for
sessions that include projectors or computers running
NMPJ V1.0.
On : Images displayed on the computer are
transferred with accompanying sounds to
the projector. This sound is produced by
the projector showing the images at the
same time as the images.
This function is available when projecting
from a single computer, or during
projection from multiple computers, when
projecting an enlarged image from one
computer.
Although sound also stops when
projection is blanked from the NMPJ
software, sound does not stop when
projection is blanked from a projector, by
activating the blanking function.
Volume is automatically adjusted by the
NMPJ software.
Off : Sounds are not transferred. Audio output
from the projector is stopped.
Nickname specified when creating or joining sessions.
Cannot be changed during sessions. This option is not
shown in Direct or Broadcast Modes.
The multicast address used in Broadcast Mode can
be changed. Use this setting to change the multicast
address if it conflicts with that of other network
equipment. This option is only shown in Broadcast
Mode.
67