Optional Memory Module - Toshiba 430CDT Maintenance Manual

4.4

Optional Memory Module

Removing an Optional Memory Module
To remove an optional memory module, make sure the computer is in boot mode then follow
the steps below and refer to Figures 4-6 and 4-7.
1. Turn off the power to the computer. Disconnect the AC power cord and all
external cables connected to the computer.
2. Remove the battery pack and Optional PC card as described in Sections 4.2 and
4.3.
3. Turn the computer upside down.
4. Remove two silver M2x4 screws securing the memory module socket cover.
5. Slide your fingernail or a thin object under the cover and remove it.
Figure 4-6 Removing the memory module socket cover
6. Remove two M2x4 screws securing the module to a brace at the center of the
module.
7. Insert a thin object and lift up to disengage the connector, then grasp the module
by the edges and remove it. Some models may have a plastic tab. If so, simply
pull up on the tab to disengage the connector.
4-10
Figure 4-7 Removing the memory module
430 Series