Table of Contents
Advertisement
2.2 SUPPLEMENTARY OPTIONS (factory-set)
2.2.1
POSSIBLE OPTIONS: «DELAY» & «1/2 LOAD» (if featured)
Only one option can be selected at a time («DELAY» or «1/2 LOAD»), never both.
If featured, the option may be associated with keys [S4] or [S5] or [S6].
2.2.1.1 «DELAYED START» SELECTOR KEY Leds [LD6 LD7 LD8]
Determines the delay time before the selected cycle is started.
Press this key repeatedly until the desired delay time is displayed; the corresponding LEDs will
switch on and off.
LEDs [LD6 LD7 LD8] correspond to [3h.. 6h.. 9h..]
The LED which remains lit [LD6 LD7 LD8] indicates the selected delay time.
When the selected delay time is confirmed, the LEDs (e.g.[LD8 LD7 LD6] switch off one at a
time until all three are off.
2.2.1.2
«1/2 LOAD» SELECTOR KEY LEDs [LD4] or [LD5] or [LD12]
The 1/2 LOAD key is used to optimize the washing cyle when small quantities of dishes are to be
washed..
The washing cycle is modified when the following parameters are selected:
Exclusion of the PRE-WASH cycle (in cycles that normally include the PRE-WASH).
Reduction of the cycle time (18
Reduction of water consumption for the cycle (~ 4lt
In this case, LEDs [LD6 LD7 LD8] are not present on the control panel.
2.3
POWER FAILURE
-
A POWER FAILURE is detected if the mains power supply is interrupted for a very brief period
(between 20 and 40mSec).
-
The POWER FAILURE function consists of maintaining the cycle status information when a power
failure occurs, so that, when power is restored, the appliance resumes the cycle from the point at
which it was interrupted.
The POWER FAILURE function is as follows:
When a power failure is detected, all loads switch off simultaneously, and the energy stored in the
capacitor is used to memorize the machine status data in the EEPROM; when the power supply is
restored, this data is used to resume the cycle from the point at which it was interrupted.
TSE-P 02.01 LF
>
28 min).
).
8/35
599 34 60-32
Advertisement
Table of Contents
