Electrolux EDW 1000 Service Manual page 10

2.5 SELECTING A PROGRAMME WITH THE DELAYED START OPTION
2.5.1 PROGRAMME SELECTION (with the door closed)
®
Press [S0] to switch the dishwasher on; the "POWER ON" LED [LD0] lights.
®
Perform the procedure for selection of the programme / options as described in paragraph
(2.4.1).
®
Press one of the keys [S4] or [S5] or [S6] (i.e. the key corresponding to the delayed start
function) to select the desired delay time.
Press [S..] repeatedly; LEDS [LD6 LD7 LD8], which correspond to the possible delay times (in
hours) will light in sequence.
To cancel the delay time, press [S..] repeatedly until the LEDs switch off.
®
6 seconds after [S..] is pressed for the last time, the delayed start countdown will begin.
If the delayed start time is selected with the door open, the countdown will begin 6 seconds after
the door is closed.
2.5.2 PROGRAMME EXECUTION
®
The delayed start countdown has started.
The countdown time decreases from the maximum (9 hours) to (0 hours).
As the countdown proceeds, the time to elapse is shown by LEDs [LD8 LD7 LD6] and is updated
at intervals of 3 hours.
example: If a 9-hour delay is selected, LED [L8] will be lit; after 3 hours, this LED switches off
and LED [L7] lights; after another 3 hours, LED [L7] switches off and LED [L6] lights; three hours
later, all the LEDs are switched off.
LED [LD..] for the selected programme (and [LD..] if any options have been selected) remain lit
for the entire duration of the countdown.
The cycle phase LEDs [LD9 LD10 LD11] remain unlit.
All the keys are disabled (i.e. none of the parameters can be modified) with the exception of the
key for the selected programme, which can be used to cancel the programme, and the DELAY
key, which can be used to modify or cancel the delayed-start function.
®
The countdown is not interrupted if the door is opened.
®
At the end of the countdown (i.e. when LEDs [LD6 LD7 LD8] all switch off), the washing
programme starts automatically.
The cycle phase LED [LD9] relative to the programme being performed lights.
®
From this point, repeat the steps described in the previous paragraphs (from 2.4.2 on).
2.5.2.1 CANCELLING THE DELAYED START OPTION
®
To cancel the delayed start option, press the DELAY key [S..] repeateadly until the LEDs [LD8
LD7 LD6] switch off; after 6 seconds, the programme will start automatically.
TSE-P 02.01 LF 10/35 599 34 60-32