Table of Contents
Advertisement
5.5
SPECIAL REGENERATION CYCLE
With the new water softening system, the "special regeneration" process is controlled electronically,
and is subdivided into 5 levels as follows:
LEVEL
DEFINITION
WH1
WH2
* WH3
WH4
WH5
*
Level set in the factory
5.5.1 DEFINITION OF THE SYSTEM
Cycle counting for the "special" regeneration process is performed by the electronic control system,
and is based on the number of fill phases rather than on the number of cycles; this makes the process
independent of the number and type of programmes performed.
Each time regeneration is performed, the chamber is emptied completely (about 240 cc of water).
Cycle calculation is based on a programme with 4 fill phases.
Modification of the regeneration level automatically results in regeneration being performed in the
subsequent cycle, irrespective of the number of fill phases performed previously.
With the new board, regeneration is always performed in the first cycle, irresepective of the
regeneration level selected.
If level [WH1] is selected, the regeneration process is not performed, and LED [LD13] remains unlit.
5.5.2 SELECTING THE REGENERATION LEVEL
With the dishwasher switched OFF
(programme selection mode)
1 Press and hold down keys [S1] & [S2]
simultaneously
2. Press the START key [S0]
LED [LD1] lights (fixed) for 5seconds, and then begins to flash to indicate the level of
regeneration selected.
example: WH3 = ( 3 flashes – 5 seconds pause) x 60 seconds (repeated).
3. To modify the level, press [S1] repeatedly.
Ä Each time [S1] is pressed, the regeneration level is modified; as a result, the flashing of LED
[LD1] changes.
The last level selected is stored in memory automatically after 60 seconds, after which the
dishwasher returns to programme selection mode.
LED [LD1] remains lit (fixed), while the cycle phase LEDs [LD9] & [LD10] flash.
To exit the regeneration level selection process, press the START key [S0].
TSE-P 02.01 LF
REGENERATION VALUES
INDICATION
WASHING CYCLE
Led [ LD1 ]
AUTONOMY REGENERATION
1 flash
2 flashes
5 cycles
3 flashes
3 cycles
4 flashes
2 cycles
5 flashes
Regeneration in every cycle
19/35
No regeneration
in the 6th cycle
in the 4th cycle
in the 3rd cycle
Vertical version
FILL
WATER HARDNESS
PHASES
Nº
º F (TH)
-
0 > 8
24
9 > 30
16
31 > 50
12
51 > 70
4
71 > 90
Horizontal version
599 34 60-32
º D (dH)
0 > 4
5 > 18
19 > 29
30 > 40
41 > 50
Advertisement
Table of Contents
