Table of Contents
Advertisement
6
«ACTIVE» DRYING SYSTEM
The "Active Plus" drying system features a close integrated circuit with bidirectional convective
movement ; air is drawn in from the exterior thus allowing the circulation of the inner warm air.
6.1
DEFINITION OF THE SYSTEM
The drying system is based on the natural circulation of the hot air produced during the hot rinse cycle,
in which the steam (humid hot air) circulates slowly through two ducts, this activating the process of
condensation.
Some of the steam enters from the lower section through the steam venting ring; this steam
circulates inside the chamber where it condenses.
The remaining part of the steam is expelled from the upper section of the tub via the external upper
duct linked with the lateral duct, in communication with the condensation chamber; in this junction
point (which isn't waterproof) the cold air from the exterior convenes in the system, thus allowing
the circulation of the inner warm air.
The condensation water sediments at the bottom of the chamber communicating with the hydraulic
system.
The duration of the drying cycle is approximately 10 minutes.
TSE-P 02.01 LF
20/35
599 34 60-32
Advertisement
Table of Contents
