Monte Carlo Fan Company 5DCR60XX Owner's Manual page 4

19
Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3" lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
22
Raise the canopy up and align the
two holes in the canopy with the two
holes in the hanger bracket. Secure
with two screws provided.
25
Install 3 screws and washers per
blade and tighten securely. Repeat
for all 5 blades.
28
Install the switch housing plate by
aligning the 2 screws with the 2 key
slot holes on the plate and twist to
lock into place. Install the 1 screw
removed and tighten the other 2
screws securely.
20
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
23
Place the gasket onto the blade
bracket as shown above.
26
Attach blade assembly to motor
using the motor screws and washers
provided. Tighten screws securely.
29
Remove the 3 screws on the switch
housing plate and save.
21
House
Black
White
Green
Make sure that all exposed wiring is
secured inside wire nuts. Note: Wires
from house may vary in color and
may not include ground wire. After
wiring is conplete, gently push wires
into junction box with wire nuts
pointing upward. Refer to point 3 of
safety tips.
24
Warning: Only blades that come
with the fan are accepatable for
installation.
Place blade onto blade bracket with
gasket.
27
Loosen 2 screws and remove 1 screw
and save.
30
Install the switch housing using the
three screws previously removed.
Fan
Black
White
Green(downrod)
Green(Bracket)