Table Of Contents - Aerco KC Series Installation, Operation & Maintenance Instructions Manual

GF-105 THE AERCO KC1000 GAS FIRED DOMESTIC WATER HEATER
Section 1
Section 2
2.1 Receiving the Unit
2.2 Unpacking
2.3 Installation
2.4 Gas Supply Piping
2.5 Electrical Supply
Section 3
3.1 The Control Panel
3.2 The Temperature Controller
3.3 The Primary Menu
3.4 The Secondary Menu
3.5 The Annunciator Circuit
3.6 The Combustion Safeguard
Controller
Section 4
4.1 Initial Start-Up requirements
4.2 Tools and Instrumentation for
Combustion Calibration
4.3 Combustion Calibration
4.4 Propane Combustion Calibration
Section 5
5.1 Testing of Safety Devices
5.2 Gas Pressure Fault Test
5.3 Low Water Level Fault Test
5.4 Water Temperature Fault Test
Operating & Maintenance Instructions
FOREWORD
SAFETY PRECAUTIONS--------------------------------1
INSTALLATION PROCEDURES-----------------------2
CONTROL PANEL COMPONENTS
and OPERATING PROCEDURES------------9
INITIAL START-UP--------------------------------------17
SAFETY DEVICE TESTING
PROCEDURES-----------------------------------25
2.6 Field Control Wiring
2.7 Flue Gas Vent Installation
2.8 Combustion Air
2.9 Unit Initial Fill
3.7 Water Level Test and Reset Switches
3.8 On\Off Switch
3.9 Starting Sequence
3.10 After Flame
3.11 Flame Test Jacks
3.12 Start\Stop Levels
3.13 Auto Restarts
4.5 Unit Reassembly
4.6 Temperature Control Calibration
4.7 Over Temperature Limit Switch
Adjustments
5.5 Flame Fault Test
5.6 Air Pressure Fault Test
5.7 Purge Interlocks Fault Test
5.8 Safety Pressure Relief Valve Test
i
CONTENTS