Table of Contents
Advertisement
INTRODUCTION TO YOUR NEW
R 401 BOWL CUTTER/VEGETABLE
PREPARATION ATTACHMENT
The food processor is perfectly geared to your
professional needs. It can perform any number of
tasks to meet all your professional needs.
The R 401 consists of a cutter bowl and a vegetable
preparation attachment. With the cutter bowl, the
R 401 can be used to process meats, vegetables,
fine stuffing, and mousse. Grinding, chopping,
kneading, and pureeing are all possible, and most
operations can be performed in 3 minutes or less.
A wide range of cutting plates is available for use
with the vegetable preparation attachment. Slicing,
grating, and julienne operations can all be achieved
with the vegetable preparation attachment.
Its numerous functions will open the door to a whole
new culinary world.
Thanks to its simple design, all components requiring
frequent handling for maintenance or cleaning can
easily be removed for cleaning and maintenance.
This manual contains impor tant information
designed to help you get the most out of your R 401
cutter bowl/vegetable preparation device.
We therefore recommend that you read it carefully
before using your machine.
We have also included a few examples to help you
get the feel of your new machine and appreciate its
numerous advantages.
SWITCHING ON
THE MACHINE
• ADVICE ON ELECTRICAL CONNECTIONS
Before plugging in, check that your power supply
corresponds to that indicated on the machine's
serial number plate.
6
W A R N I N G
This appliance must be plugged into an
grounded socket (risk of electrocution).
The R 401 is fitted with a single phase motor:
120 V / 60 Hz
The machine comes with a single phase plug
connected to a power supply cord.
• CONTROL PANEL
R 401
Red switch
= Off switch
Green switch
= On switch
Black switch
= Pulse control
• CUTTER BOWL ATTACHMENT
1) With the motor base
facing you, place the
bowl onto the motor base
with the handle toward
the front. Turn the bowl
just off-center and to the
left as you lower it onto
the base.
2) Then, turn the bowl
back to the right (coun-
terclockwise) locking it
onto the motor base
tabs.
3) Place the blade
assembly onto the motor
shaft. Rotate the blade
assembly until it drops
into place. The bottom
blade should be level
with and just off the bot-
tom of the bowl.
ASSEMBLY
The device is now ready for use.
• VEGETABLE PREPARATION ATTACHMENT
1) The vegetable prepa-
ration
attachment
consists of two deta-
chable parts: the conti-
nuous feed attachment
and the continuous feed
lead.
4) Note the plastic tab
on the bowl lid. Place the
lid on the bowl with the
tab turned to the front
and slightly to the left of
the bowl handle; then,
turn the lid back to the
right until it comes to a
stop with the tab over the
bowl handle.
Advertisement
Table of Contents
