Placement And Alignment - JEFF ROWLAND CORUS STEREO PREAMPLIFIER Operational Manual

PLACEMENT AND ALIGNMENT

Place the on a stable platform, rack, or shelf. The power supply
CORUS PREAMPLIFIER
can be placed up to two meters away from the preamplifier. All audio interconnects can
be inserted into the rear panel at this time. Then each multi-pin DC cable can be inserted
into the DC out receptacles. Partially insert each cable connector shell and rotate until
alignment is achieved. Then firmly push cable shell until it locks in place. A snap will be
felt and heard when the cable is correctly inserted. Repeat the same procedure when
installing the DC cables into the power supply. To remove cables, grasp the outer sliding
sleeve of each cable between your fingers and pull sliding sleeve and cable away from
the chassis connector.
NOTE: DO NOT FORCE CABLE INTO RECEPTACLE UNLESS ALIGNMENT IS ACHIEVED.
After all interconnect and DC cables have been installed into both units, plug in the AC
power cord into the power supply. The other end of the power cord may then be plugged
into any AC mains source from 85 to 265 volts AC. The rocker power switch on the
power supply may be turned on at this time.
NOTE: THE PREAMPLIFIER IS BEST LEFT POWERED ON INDEFINITELY TO ENSURE OPTIMUM
OPERATING CHARACTERISTICS.
WARNING: THE CORUS PREAMPLIFIER MUST BE CONNECTED TO THE POWER SUPPLY VIA THE
DC POWER CABLES BEFORE APPLYING AC POWER TO THE POWER SUPPLY. FAILURE TO
FOLLOW THIS INSTALLATION SEQUENCE MAY RESULT IN DAMAGE TO INTERNAL POWER
SUPPLY COMPONENTS.
10