Schedule Configuration - D-Link DNS-722-4 User Manual

Section 3 - Configuration
Set Recording Schedule Configuration
Step 1: Enter the desired Start Time and End
Time.
Step 2: Enter pre-record period and post-record for
event trigger recording.
Step 3: Check the enable audio box to record audio
from your camera (if supported).
Step 4: Choose the recording mode and the trigger
source.
Step 5: Press OK to add this new schedule.
Step 6: If you would like to add another new schedule,
click the Insert button.
Note
• The Always Record option will start recording immediately.
• When configuring the Motion Detection event, be sure to set up the motion detection function on your camera first.
• After changing the motion detection settings of your camera, be sure to disconnect the camera from the NVR and then re-connect it to update all new
changes.
• When setting up an event, a video motion or digital input can be used to trigger the other cameras. This means that when motion is detected by a camera,
the NVR can send out warning signals to the other connected cameras.
• Alternatively users can drag the time bar to change the recording period. The red bar represents the Always Record feature and the blue bar represents
the Event Recording feature.
*DNS-722-4 does not support "Record on event" function.
D-Link DNS-722-4/DNS-726-4 User Manual

Schedule Configuration

36