Status Lights; Power Light; Wi-Fi Connectivity Led - Kodak ESP OFFICE 2100 Extended User Manual

Troubleshooting

Status lights

Power light

Wi-Fi connectivity LED

112
There are three status lights on the printer: the power status light (on the on/off
button) indicates power, the Wi-Fi status light indicates Wi-Fi status, and the
attention light blinks when an error occurs.
Power light
Off
Blinking
On
Wi-Fi connectivity LED
Off
Blinks continuously
Blinks intermittently
On
www.kodak.com/go/aiosupport
What it means
• The printer is turned off.
– Press the power button to turn on power.
• The printer does not have power.
– Make sure that the power cord is plugged into the
back of the printer and into an electrical outlet, and
that the electrical outlet has power.
• The printer is busy.
– Wait for the printer to finish the task.
The printer is ready.
What it means
The Wi-Fi radio is either turned off or is turned on but not
connected to a wireless network.
The Wi-Fi radio is turned on, and the printer is searching for
available wireless networks within range.
The Wi-Fi radio is turned on and the printer cannot find any
available wireless networks within range, or the Wi-Fi radio
connection has been interrupted, or is too weak to send
signals to and from the printer.
To find and connect to an available wireless network within
range, press OK, turn the Wi-Fi radio off, and run the Wi-Fi
Setup Wizard (see Connecting to a wireless network,
page 6).
The Wi-Fi radio is turned on, and there is a working
connection between the printer and a wireless network.