Changing The Assigned Parameter; (Effects/Assign); Automatically Playing Arpeggios (Arpeggio); Playing An Arpeggio - Roland GAIA Synthesizer SH-01 Owner's Manual

Changing the Assigned Parameter

(EFFECTS/ASSIGN)

1. Press the [EFFECTS/ASSIGN] button so it's lit.
2. While playing the keyboard, position your hand over
the D beam controller, then move it up and down.
Parameters assigned on an individual patch basis will change.
Press the [EFFECTS/ASSIGN] button to turn off its illumina-
tion; the D BEAM will turn off.
Since you can assign a variety of functions to the
[EFFECTS/ASSIGN] button, use it to apply various effects to
the sound in real time (p. 48).
Determining the polarity of the D
BEAM (D BEAM POLARITY)
The changes in the value of the parameter assigned to
the D beam can be made to occur in either the positive or
negative directions.
The polarity is determined by the direction that you move
the knob at the time that the parameter is assigned.
When you move your hand near the D Beam controller, the
value will change in the same direction as it did when you
turned the knob.
For example, if you hold down the D BEAM [EFFECTS/
ASSIGN] button while you turn the OSC [PITCH] knob to
the right, the pitch will rise when you place your hand near
the D beam controller.
Conversely, if you turn the OSC [PITCH] knob to the left
while you hold down the D BEAM [EFFECTS/ASSIGN]
button, the pitch will descend when you place your hand
near the D beam controller.
Holding Notes After Removing
Your Hand from the Keyboard
(KEY HOLD)
You can make notes continue sounding even after you
take your hand off the keyboard.
1. Press the [KEY HOLD] button so it's lit; key hold
will be turned on.
When you play a new key, the previously sounding note will
stop sounding, and only the newly played note will be heard.
If the arpeggiator is on, turning key hold on will cause the
arpeggio to continue sounding.
22
Automatically Playing Arpeggios
(ARPEGGIO)
Press the [ARPEGGIO] button so it's lit; the arpeggiator will
be on.

Playing an Arpeggio

1. Press the [ARPEGGIO] button so it's lit; the
arpeggiator will be on.
Press a chord on the keyboard; an arpeggio will sound
according to the settings stored for each patch.
If you press the [KEY HOLD] button so it's lit, the arpeggio
will continue sounding.
When you play a chord on the keyboard, an arpeggio will
be produced according to the settings stored for each
patch, and the arpeggio will continue sounding even after
you take your hand off the keyboard. When you play a
different chord, the notes of the arpeggio will also change.
To stop the arpeggio, turn off the arpeggiator.
To turn off the arpeggiator, press the [ARPEGGIO] button
so it goes out.