Roland SH-01a Installation Manual

Hide thumbs Also See for SH-01a:

Roland SH-01a "Colors" Sound Pack Installation Guide

Installation

Before transferring any Sound Sets to your Synth, please make a backup of

your sounds!

Please follow these steps to transfer the Desert Sound Pack to your SH-01a.

To mount the SH-01A to your desktop follow this procedure

1. Holding down [MENU] button, power up the SH-01A

2. Connect your computer to the SH-01A USB port via USB cable

3. Open the SH-01A drive which has mounted to your desktop.  

To transfer patches from your computer into the SH-01a

1. Follow the above procedure for mounting the SH-01A  

2. Copy the patches you'd like to check out into the "RESTORE" folder on  

the SH-01A drive.  

3. When copying is completed, eject the SH-01A drive.

4. IMPORTANT - Before power cycling the module press the [MENU] button

Table of Contents

Do you have a question about the SH-01a and is the answer not in the manual?

Page 1 Before transferring any Sound Sets to your Synth, please make a backup of your sounds! Please follow these steps to transfer the Desert Sound Pack to your SH-01a. To mount the SH-01A to your desktop follow this procedure 1. Holding down [MENU] button, power up the SH-01A 2.
Page 2 5. Once the lights stop blinking you may power cycle the SH-01A and disconnect the USB cable and you’re done.   The last three steps are crucial in order to get this sound pack working properly. Trouble Shooting: 1. Sometimes, you have to create a new folder called „PATCH“. For whatever reason it doesn’t show up where it should be.
Page 3 2. The licensee may modify the Sounds and may use the Sounds for commercial purposes as part of a musical composition with other Sounds. 3. The Licensee MAY NOT use the Sounds in isolation within any competitive product that is sold, redistributed or relicensed to third parties. That includes i.e.