b. Press the tab
Figure 15. Opening the cover of the front-access storage enclosure
c. Open the handles on both sides of the hard disk drive bracket. Then, pull the bracket out of
the front-access storage enclosure.
• If you are replacing a storage drive, do the following:
a. Remove the front-access storage enclosure from the optical drive bay. See "Removing and
installing a device in an optical drive bay" on page 130.
b. Press the tab
Figure 16. Opening the cover of the front-access storage enclosure
c. Open the handles on both sides of the hard disk drive bracket. Then, pull the bracket with the
storage drive out of the front-access storage enclosure.
d. Remove the storage drive from the bracket. See step 5 on page 113.
6. Install the new storage drive into the storage drive bracket. See step 6 on page 115.
7. Note the orientation of the connector on the storage drive and you might need to turn over the bracket.
Then, slide the bracket with the new storage drive into the front-access storage enclosure until it snaps
into position.
1
as shown to open the cover of the front-access storage enclosure.
1
as shown to open the cover of the front-access storage enclosure.
.
Chapter 11
Installing or replacing hardware
1
1
117