Advertisement
Environ 3 Infrared Remote Transmitter
OPERATION
Enabling Keypads to Receive IR Signals
A wall keypad must be enabled in order to receive the IR signal from the IR Remote. To
enable the keypad, do the following:
Step 1. At keypad, press and hold A and D buttons for 3
seconds. A, B, C, D and OFF keys will illuminate
with one of them blinking. Button A refers to the
keypad being configured as Room 1, B to Room 2,
C to Room 3, and D to Room 4. If OFF is blinking,
IR is disabled. (Refer to the drawing at right.) The
factory default is Room 1 (A).
Step 2. Press desired Room (A, B, C, or D) or OFF. This
will configure the keypad as that room or disable
IR input. The selection will blink.
Step 3. Press ON to Save and Exit.
Using the Infrared Remote Transmitter
The Environ 3 Infrared Remote can operate in all four Room modes. On the IR Remote, you
must first press a Room button to place it in that mode. For example, pressing the Rm2 button
sets the Remote in Room 2 mode. The IR Remote will then control any Master Station pro-
grammed to receive that specific room's commands.
On and Off
Presets
B
Rooms
Raise/
Lower
Figure 1: IR Remote Layout
ON
OFF
A
C
D
Rm1
Rm2
Rm3
Rm4
Operation Guide
A-D
(Room)
Buttons
3
Advertisement
