Burners; Igniters - Jenn-Air Pro-Style PRD3030 Use & Care Manual

CARE AND MAINTENANCE

BURNERS

For proper lighting and performance
keep the burners clean. It is necessary
to clean the burners if they do not light
even though the igniter clicks, if there
has been a severe boil over, or when
the flame does not burn blue. Be
certain all burner knobs are in the off
position before attempting to clean
the burners. The burners have been
designed for ease in cleaning. When
the grates and burners are cool,
remove the grate. The burner cap and
the brass port ring can easily be lifted
off. Wash these parts in hot soapy
water, rinse and dry thoroughly. The
burner caps are porcelain enamel,
follow the directions on the previous
page that were given for the burner
grates. A bristle brush can be used to
clean out the toothed burner ports, if
necessary. After cleaning, it is
important to make sure the locating
pins on the bottom side of the port
ring are properly aligned with the
corresponding holes in the base.
Incorrect alignment will produce a
potentially dangerous flame and poor
burner performance (see fig. 13).

IGNITERS

Wipe with a water dampened cotton swab. Be careful
not to damage the igniter (see fig. 15).
Brass Ring
Locating Pin
Locating Notch
Electrode
Fig. 13
IGNITER (KEEP CLEAN)
27
Cap
Main
Burner
Port
Ring
Burner
Base
Venturi
Locating Pin
Locating Notch
Fig. 14
Fig. 15