Table of Contents
Advertisement
Level meter
*
If the level meter swings and "
means the recording level is too high. Adjust the level
within the "
" range even if the recording sound
reaches the highest level.
*
The input level (volume input to this unit) for recording
is combination of the recording level and microphone
sensitivity.
The input level image is as below.
Recording
1
level
MIC SENS.
*
No sound is recorded at the recording level 0.
*
The recording level can also be adjusted during
recording or while recording is paused.
*
When [MENU] is pressed during recording standby, the
microphone sensitivity (➜ page 21), "LOW CUT FILTER"
(➜ page 21) and recording EQ (➜ page 24) can be set.
OVER indication
Recording level
" is displayed, this
30 1
30
LOW
HIGH
Setting the recording peak limiter to ON
Even if the recording level adjustment is MANUAL,
when the excessive volume is input, the recording
level is automatically adjusted and the sound
distortion is reduced.
• Press [g STOP/RETURN] to stop the unit.
1
Press [MENU].
2
Press +, – to select "MIC REC MENU"
and press [q OK] to enter.
3
Press +, – to select "PEAK LIMITER"
and press [q OK] to enter.
4
Press +, – to select "ON"
and press [q OK] to enter.
(The factory setting is "OFF".)
To exit the setting screen, press [F2 (CLOSE)].
*
When the recording level adjustment is AUTO, the
recording peak limiter function will be activated
regardless of the above setting.
*
If the level meter swings, "
of the recording peak limiter setting.
" is displayed regardless
23
Hide quick links:
Advertisement
Table of Contents
