Rear Panel Connections - McIntosh C15 Owner's Manual

C15 Rear Panel Connections
DATA PORTs send
signals to compat-
ible source compo-
nents to allow you
to remote control
them.
Connect the C15
power cord to a live
AC outlet. Refer to
information on the
back panel to deter-
mine the correct
voltage.
The EXT The SUM Data
(external) Port connects
Sensor for a to a McIntosh
McIntosh Remote Con-
Keypad or trol Translator
IR sensor.
POWER
CONTROL
Outputs send
turn-on sig-
nal to a
McIntosh
Component.
6
PROCESSOR
FROM and TO
jacks for a signal
processor
OUTPUTS 1 and 2
the signal output
controlled by the
front panel OUT-
PUTS push-buttons
TAPE OUT-
PUTS supply
record signals for
tape recorders
The HOME PROCESSOR
Data Port is for IN/OUT Switch
use with the op- turns the signal
tional HC-1 processor loop
Home Control- On or Off
ler.
C15 Rear Panel Connections
TUNER inputs
accept signals
from the output
of a tuner.
TAPE inputs PH (Phono)/AUX IN-
are for tape PUTS accept signals
recorders from a Moving Magnet
phono cartridge or an
audio high level signal,
depending on the posi-
tion of the PH/AUX
Switch
VIDEO inputs
for audio signals
from a LD, VCR,
TV or the op-
tional MVS-3 A/
V Selector.
CD1 and CD2
inputs accept
signals from
separate CD
players.
GND terminal
accepts a
ground wire
from a turn-
table.
The PH/AUX
Switch selects
signals from a
Moving Magnet
phono cartridge or
an audio high
level signal