Mitsubishi Electric PAR-U01MEDU Smart ME Instruction Book page 19

Auto (dual set point) and Setback modes:
When the operation mode is set to the Auto (dual set point) mode or the Setback mode, two
set temperatures (one each for cooling and heating) can be set. Depending on the room
temperature, indoor unit will automatically operate in either the cooling or heating mode and
keep the room temperature within the preset range.
■ Differences between the two modes
• Auto (dual set point) mode
The set temperatures that are specified for the Cool/Drying mode and the Heat mode
will be used to automatically control the room temperature to stay within the set
temperatures. This mode is especially effective during the in-between seasons, when the
temperature difference between the highest and the lowest is large and both heating and
cooling modes are used within the same day.
Set temp.
(Cool)
Set temp.
(Heat)
• Setback mode
Room temperature is controlled to stay within the set temperature range that is specified
for the Setback mode. By leaving sufficient temperature differential between the set
temperature for cooling (upper limit) and heating (lower limit), it is possible to keep the
room temperature within the specified range without overworking the air conditioners.
This setting will be especially effective during periods of non-occupancy.
Set temp.
(Setback_Cool)
Set temp.
(Setback_Heat)
Operation pattern during Auto (dual set point) mode
Heat
Operation pattern during Setback mode
Heat
The room temperature
changes corresponding
to the change in the
outside temperature.
Cool Heat
The room temperature
changes corresponding
to the change in the
outside temperature.
Cool Heat
Basic operations
Room
temperature
Cool
Room
temperature
Cool
19