Intended Use - Weller WXHAP 200 Operating Instructions Manual

4-7
Always pass on the WXHAP 200 on to third parties along with these
operating instructions. The manufacturer shall not be liable for
damage resulting from misuse of the machine or unauthorized
alterations
− State of California warning:
When used for soldering and similar applications, this product
produces chemicals known to the State of California to cause
cancer and birth defects or other reproductive harm.
2.1 Please observe the following:
− Always place the hot air tool in its original stand.
− Remove all flammable objects from the vicinity of the hot soldering
tool.
− Do not connect flammable gases to your hot air equipment.
− Always wear suitable protective clothing when using the
WXHAP 200.
− Do not direct the hot air jet at persons or look into the hot air jet.
− Never leave the hot WXHAP 200 unattended.
− Do not carry out work on live parts
− When using inert gases, make sure the area is well ventilated.
− Read and observe the operating instructions of your control unit.
− Read and follow the operating instructions for the Weller WXA 2
supply unit.
2.2

Intended use

Use the WXHAP 200 exclusively for the purpose indicated in the
operating instructions of releasing, accommodating and setting down
chip components under the conditions specified here. Intended use
of the WXHAP 200 also includes that
− you read and follow these instructions,
− you read and follow all additional accompanying documents,
− you observe the national accident-prevention regulations
applicable at the location where the device is used.
The manufacturer accepts no liability for damages resulting from
failure to use the device in compliance with these operating
instructions or unauthorised modifications to the device.
WXHAP 200